Hello, folks! Any advice about letterpress printing paper bags? We have a Challenge 15MP proof press and two table top platen presses at our shop. I've read suggestions on Briar Press about using softer polymer or rubber plates and/or printing with a rubber blanket on the cylinder/platen. We welcome any suggestions! Thanks so much.

Views: 79

Reply to This

Replies to This Discussion

We've done it with the polymer with great results! The image had both fine areas as well as an area with fuller coverage & the outcome looked great

Thanks Megan! Glad to hear it. Did you have to do anything special in terms of packing?

We ran ours on a Heidelberg Windmill and used a normal makeready. Good Luck!

Great! Thanks so much.

Depending on how soft the bag material is (Kraft something or other, I'm guessing?) I reduce my platen packing and slip a sheet of red board into the bag to keep the impression from going through. It takes an extra couple of seconds per print, but it's worth it!

RSS

Photos

Loading…
  • Add Photos
  • View All

LetterpressConference.co

LoLP Book + Shirts + More

Videos

  • Add Videos
  • View All

Badge

Loading…

© 2017   Created by Kseniya Thomas.   Powered by

Badges  |  Report an Issue  |  Terms of Service