Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts

  • Courtney Peters
    Participant
    @courtneypeters
    2 years, 11 months ago

    Hello!  I have been wondering about proper packing on my SP-20. I have a Galley Bed Plate with 040 cylinder undercut. I have Vandercook Tympan, .003 packing sheets and a Mylar sheet.

     

    Everything I can find as to how much packing you need does not mention if the thickness of the bed plate is involved or not.

     

    If I use one piece of Tympan, the mylar and 5 packing sheets. Its not enough to make an impression in 80lb lettra. 

     

    I’m worried that if I add any more thickness to the packing I may be counterproductive.  and of course I do not have a micrometer (Yet)!

     

    Any advice would be great.


    kelly mcmahon
    Participant
    @kellymcmahon
    2 years, 11 months ago

    Firstly, your bed plate shouldn’t matter to anything, as long as it’s level and brings your type/plates up to type high.

    Vandercook recommends no more than .03 over the undercut–so you’d want you paper and tympan/packing thickness to total .43. I find that with Lettra (because it’s so soft), you want a bit more than that–closer to .50.

    (I’m not sure what Lettra you’re using that’s 80lb. Is it the text weight?)

    Lettra 110# is .021

    Tympan is generally a standard .06

    I don’t use mylar, so I can’t speak to its thickness, but you should be able to find that info on the packaging and/or the place you purchased it.

    With 110# Lettra, I use 1 tympan top sheet (the diecut piece that goes under the gripper bar and around the tightening rod), plus 3-5 tympan packing sheets, depending on the amount of impression I want, and whether the printing is double sided.

    Hope that’s helpful!

    Kelly

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.