Activity
-
Spring Munsel Gideon became a registered member 3 years, 11 months ago
-
Elizabeth A Ellsworth became a registered member 3 years, 11 months ago
-
Fleming Garner-Parker became a registered member 3 years, 11 months ago
-
Dani became a registered member 3 years, 11 months ago
-
Leslie Ross-Robertson changed their profile picture 3 years, 11 months ago
-
Leslie Ross-Robertson changed their profile picture 3 years, 11 months ago
-
Leslie Ross-Robertson's profile was updated 3 years, 11 months ago
-
laureng started the topic Craftsman Superior 6.5×10 Tabletop Platen Press For Sale in the forum Classifieds 3 years, 11 months ago
Craftsman Superior 6.5×10 Tabletop Platen Press For Sale.
Purchased around 2006 from Dave Churchman. Have printed hundreds of cards and small prints, was being used periodically until 2 years ago. Press was oiled when in use and always kept in the house/under climate control. In good shape, one of the Side Arm Washer Screws head sheared off, but…[Read more]
-
Sol Columbus started the topic Complete Shop for Sale in the forum Classifieds 3 years, 11 months ago
Kelsey Excelsior 6” x 10” press; ATF Chief 15 press with Kolormate dampening system; Argyle horizontal camera, 33% to 300%; Magnum platemaker; Chandler and Price hand-operated guillotije paper cutter, 26” mouth, extra blade; Baum Ultrafold 714; Spinnit one hole paper drill; Pinbar plate punch; Light table; All equipment is in working condi…[Read more]
-
Sol Columbus became a registered member 3 years, 11 months ago
-
nadine became a registered member 3 years, 11 months ago
-
Martha O'Curry became a registered member 3 years, 11 months ago
-
Kelly Lye changed their profile picture 3 years, 11 months ago
-
Kelly Lye's profile was updated 3 years, 11 months ago
-
Arie Koelewyn replied to the topic Lubricant for trucks and rollers and other parts of C&P pilot in the forum Press Troubleshooting, Tips, and Help 3 years, 12 months ago
No one else has answered…I don’t own a C&P pilot, but I think the cores of Pilots have a tab or two pinched out that the trucks go over…there is a slot in the truck for them to fit into. Ideally the trucks do not rotate independently of the roller, they should roll with the roller. This one reason the trucks should be the same size as the…[Read more]
-
Gen Harrison changed their profile picture 4 years ago
-
Jo Olive changed their profile picture 4 years ago
-
Jo Olive's profile was updated 4 years ago
-
Marissa Fuher became a registered member 4 years ago
-
Megan became a registered member 4 years ago
- Load More