We ran ours on a Heidelberg Windmill and used a normal makeready. Good Luck!

We’ve done it with the polymer with great results! The image had both fine areas as well as an area with fuller coverage & the outcome looked great

Thank you again, that’s good advice! I’ll give it a try.

Hi David, Thank you, yes, the job is done & gone but I’m still going to question movement/shift if I place anything UNDER the counter. Are you sure just tape would not cause any movement?

Hi CamilleI’m setting up on a Heidelberg Windmill & yes, I’m using heat. My concern or question here is that I typically use duploflex tape to mount my counter to the platen. If I place paper UNDER the counter, I’m concerned it will move/shift, possibly causing damage to the die or counter. This is a $600.00 die & I don’t want to screw it up! I…[Read more]