Two thoughts:

1. Check to see if the pulley is turning.

2. If not, check to see if the motor shaft itself is turning.

Lots of non-motor possibilities: the pulley may be stripped, the belt may be stretched, or the motor may have shifted, releasing tension on the belt, or (less likely) may have shifted in such a way as to bind.

If the problem…[Read more]

Hey Patricia!

First of all, congrats on being bitten by the print bug. Secondly, these are both decent prices. Rollers will cost you a couple hundred bucks for the Craftsman, but it’s a bit stronger press than the Kelsey. You’ll need to spend some more money though, to really get started. I’d budget for an extra $300-400 in additional suppl…[Read more]

Hey Rhonda,

There’s a great Heidelberg guy in Atlanta that gives workshops named Gale Lightfoot. Incidentally, his wife is named Gail. 😂

Depending on how soft the bag material is (Kraft something or other, I’m guessing?) I reduce my platen packing and slip a sheet of red board into the bag to keep the impression from going through. It takes an extra couple of seconds per print, but it’s worth it!

Hi, Davina!  I’m using a variable speed controller with a 3hp motor, which is actually a little overkill for my 12×18. I couldn’t even tell you who makes the motor — you just want a 3-phase general purpose enclosed motor (2hp or higher, since getting the wheel started from low speed takes some torque), with a fan cooling system. The controller s…[Read more]

Are the Lemon Drop A2s still available? I’d like them.  Also, let me know if you have any pre-cut A2 stock.  Thanks!